EdgeStar AP10000HW - Manual (Page 12)

12
Operation – Using the Remote Control
Operation – Adjusting the Louvers
Regulating air flow direction
FIG.14
Move the roller on the air vent to the
left or right to control the air flow
direction.
NOTICE !
1.
To prolong the compressor's life, please wait at least 3 minutes before turning the
unit back on after shutting it off.
2. The cooling system will shut off if the ambient temperature is lower than the set one.
The fan, however, keeps working on the set level. If the ambient temperature rises
above the selected level, the cooling system will return to operation.
All the control panel functions can also
be set with the remote control.
1. LED Indicator – Lights up when
you press any of the buttons.
2. Power Button – Used to power the
unit on or off
3. Mode Button – Used to change
between auto, cooling, heating, or
fan modes.
4. Timer Button – Used to set the
timer function.
5. Up Button – Used to increase the
temperature.
6. Down Button – Used to decrease
the temperature.
7. Fan Speed Button – Used to set
the fan speed.
1
2
3
4
5
6
7
Note: The
remote uses
two AAA
batteries.
higher than the set one(still, the ventilation keeps working on the set level).
As the ambient temperature drops below the selected level, the heating will
order to melt the frost. As this occurs, just wait for the heating returns to work.
function during low temperature, sometimes the heating will stop for a while in
return to work.
3. On the contrary, the heating will swith off if the ambient temperature is
4. This machine is equipped with ANTI-FROST function. While using the heating