Cable k2 raid, K2 raid basic online/production, Cable k2 devices – Grass Valley K2 Storage v.9.0 User Manual
Page 25
Cable K2 RAID
Before cabling, install the K2 RAID chassis in its permanent location. After mounting the chassis
in the rack, you must secure brackets to the front rail to support the Grass Valley bezel. Refer to
related topics in "K2 SAN Installation and Service Manual" for rack mount instructions.
You do not need to manually set a Fibre Channel address ID on controllers or a chassis address on
Expansion chassis.
As directed by the system diagram for your storage system, cable the K2 RAID devices using the
instructions in this section.
Once the RAID storage is connected and configured, do not swap Expansion chassis or otherwise
reconfigure storage. If you connect an Expansion chassis in a different order or to the wrong
controller, the controller will see a configuration mismatch and fault.
Related Topics
K2 RAID basic online/production
on page 25
K2 RAID redundant online/production
on page 26
on page 27
on page 28
on page 28
K2 RAID basic online/production
These cabling instructions apply to the following:
•
K2 10Gv2 RAID on a basic (non-redundant) online or production K2 SAN.
AC
DC
AC
1
0
DC
ENC ID
ENC ID/DIAG
ID
1
0
ENC ID
ENC ID/DIAG
ID
Continue this cable pattern for additional Expansion Chassis.
17 October 2012
K2 Storage Cabling Guide
25
Cable K2 devices