Grass Valley LGK-3901 - Manual (Page 58)

GUIDE TO INSTALLATION AND OPERATION
52 | LGK-3901/DSK-3901
Fill-2 – Video Loss ›
Fill-2 – Video Mismatch ›
Fill-2 – Input Timing ›
Key-2 – Video Loss ›
Key-2 – Video Mismatch ›
Key-2 – Input Timing ›
Overall Timing ›
Embed Audio Ip – Audio Feed [1 to 2]
– Channel [1 to 16] – Type Change
›
Embed Audio Ip – Audio Feed [1 to 2]
– Channel [1 to 16] – Audio Loss
›
AES Audio Ip – Pair [1 to 4] –
Channel [1 to 2] – Type Change
›
AES Audio Ip – Pair [1 to 4] –
Channel [1 to 2] – Audio Loss
›
Temp Fail ›
Voltage Fail ›
Network Link ›
CF Usage ›
Backplane Loss ›
Video FTB ›
Audio FTS ›
› : Factory default.
If the LED is Flashing Yellow, it means that the card is selected for local control using the Densité frame’s control
panel. See Section 6.3 for details.
The following styles of error condition are supported:
• Unlocked
The external reference signal is missing or bad
• Mismatch
The input signal does not match the output video standard
• Video Loss
Video is missing from the input
• Input Timing
Input timing either follows behind or is more than one line before the PGM Output
• Overall Timing
Any one of the available Input Timing errors is triggered
• Audio Type Change
Audio type changes between PCM and non-PCM
• Audio Loss
Audio signal is not present
• Temp Fail
FPGA temperature is greater than 80°C
• Voltage Fail
Any one of the available voltages is out of tolerance by ±5%
• CF Usage
The disk usage of the Compact Flash exceeds 80% of capacity
• Backplane Loss
The LGK-3901/DSK-3901 is not connected to the rear panel
• Video FTB
The most downstream keyer (DSK 5 or DSK 2) has been faded to black
• Audio FTS
Audio has been faded to silence
Alarms levels are set up via the CONFIG ALARMS front panel menu, Configurator Tool (see section 7.2) or iControl
(see section 6.4.13)