Grass Valley DDA-1113 - Manual (Page 7)

GUIDE TO INSTALLATION AND OPERATION
DDA-1113 | 7
2 Installation
2.1 Unpacking
Make sure the following items have been shipped with your
DDA-1113 . If any of the following items are missing,
contact your distributor or Miranda Technologies Inc.
For a DENSITÉ-2 frame:
DDA-1113 Digital Audio Distribution Amplifier
One of the DDA-1113 2RU rear panels
For a DENSITÉ-3 frame:
DDA-1113 Digital Audio Distribution Amplifier including 3RU adaptor
One of the DDA-1113 2RU rear panels including 3RU adaptor, or a DDA-1113-3SRP
2.2 Installation in the Densité frame
The
DDA-1113 and its associated connector rear panel must be mounted in a DENSITÉ-2 or DENSITÉ-3 frame. It is
not necessary to switch off the frame’s power when installing or removing the card. See the DENSITÉ Frame manual
for detailed instructions for installing cards and their associated rear panels.
This card is sized for DENSITÉ-2, but can be installed in DENSITÉ-3 with the use of available adapters for the
card and the rear panel.
2.3 Rear Connector Panel
When used with a dual-slot rear panel, the DDA-1113 must be installed in the right-most of the two slots covered by
the panel in order to mate with the panel’s connectors. If it is placed in the wrong slot, the front panel LED will flash
red. Move the card to other slot for correct operation. No damage will result to the card if this occurs.
Figure 2.2 3RU Rear Panel
Figure 2.1 DDA-1113 2RU Rear Panels