Grass Valley ADVC-55 - Manual (Page 13)

Installation and Operation
In
s
ta
lla
ti
o
n
a
n
d
O
p
e
ra
ti
o
n
1
Installation and Operation
13
Setting DIP Switches Setting DIP Switches Setting DIP Switches Setting DIP Switches Setting DIP Switches * * * * *
Use the DIP switches on the right side of the unit to modify the ADVC-55's functionality. Each setting
should be set before this unit is turned on. Setting of Audio Input Level can be switched during
operation.
* : All the switches have been set to OFF at the time of shipment. No.1 and No.2 may differ depending on your point of
purchase.
Video Format:
Toggles between capturing NTSC and PAL video format. When you convert video data recorded under
SECAM system, set No.1 switch to the ON (PAL) position and set No.2 switch to ON as well.
NTSC Setup Level:
Toggles between 0 IRE and 7.5 IRE when No.1 switch is set to the OFF position. NTSC Setup (output
black level) setting is available only for NTSC.
Audio Input Level:
When you feel converted sound is rather lower (smaller) than expected, set No.3 switch to the ON
position. It may make the sound larger. There is however, a possibility that the sound may be distorted
when the audio signal is over a certain level.