Grass Valley ADC-1101 - Manual (Page 14)

GUIDE TO INSTALLATION AND OPERATION
10 | ADC-1101
3.3.3 The Video Processing group
Use the controls on this panel to process the
incoming analog video before the A-to-D
conversion. The following controls are available:
3.3.4 The Audio Output group
Each of these tabs controls the output processing
for two output channels – source selectors, level
controls and mixers for each output.
The Operation Mode pulldown establishes the
configuration of the controls for an output channel.
There are four options:
A (see CH 1 in figure 3.4)
The source is selected using the Source A
ABUS Select and Channel pulldowns, and its
level is adjusted using the slider or data box.
• The ABUS select options are:
o V select one of the 16 channels from
the video card.
o A1 select one of the 16 channels from
an audio card. A1 is always Local,
Slave 1 or Master
o A2 select one of the 16 channels from
an audio card. A2 is always
Slave2 or Slave.
Figure 3.4 Audio Output group – CH 1&2 tab
• The output Level is adjustable from -96 to 0 dB with the slider or a direct keyboard entry.
Figure 3.3 Video Processing group