EverFocus EZ350 - Manual (Page 6)

5
camera, fix the screw on the front fixing plate. Make sure the wider side of the fixing plate
holds the edge of the camera well.
5. Attach the camera onto the mounting bracket.
6. Loosen the swivel screw and point the camera to the desired direction.
7. Tighten the swivel screw. To strengthen the fixing power of the swivel screw, tighten the
set-screw with the set-screw wrench (supplied).
Notes:
(A) Make wiring connections only when it is determined that power is in a disconnected
status.
(B) There is a desiccant pack attached to the housing base under the camera which is
designed to absorb any moisture trapped inside the housing during adjustment. To
avoid excessive moisture build up, it is recommended to avoid rainy or excessively
damp conditions during installation of camera. It is also advisable to limit the
frequency of removing the housing cover. The desiccant pack can be replaced if
condensation develops inside the housing.