EverFocus EZ350 - Manual (Page 5)

4
INSTALLATION
1. Using the supplied screws, mount the bracket base on the desired location.
2. Connect the BNC connector of the camera to a monitor or other video device through a 75 ohm
type coaxial cable with BNC female connector at cable extension.
3. Connect the 24VAC or 12VDC regulated power source of the camera (power jack) to the
power-in jack with 2mm plug. For 12VDC power source, please make sure the power plug is
center+ outer- for heater normal operation.
4. If the factory settings are out of focus, or any other adjustment is required, follow the
procedures below.
a. Remove the fixing screw in the front, which hold the sun shield cover. Remove the sun
shield cover.
b. Twist open and carefully remove the housing cover.
(Please pay attention to prevent damage to the “O”-Ring seal.)
c. Loosen the focal lens and focus locking screws.
d. Adjust the lens to bring the subject into focus.
(Caution: Heater elements could be hot! When camera power is on, be cautious with camera
adjustment.)
e. Retighten the screws.
f. Please refer to the Settings section for the details of the other adjustments. Adjust accordingly
if necessary.
g. When all the adjustments and settings are completed, overlaying the cover gently. Be careful
not to damage to the “O”-Ring and camera components.
h. To reassemble the sun shield, match the hole on the sun shield to the back fixing plate of