Grass Valley 2020DAC D-To-A - Manual (Page 22)

16 2020DAC Instruction Manual
2020DAC 4-Channel Audio Digital to Analog Converter
Ch 3/4 Input Status/Output Mode
The CH 3/4 INPUT STATUS/OUTPUT MODE display ( Figure 11 on page 17 ) pro-
vides status reporting and output mode selection for Ch 3 and Ch 4.
Output level adjustments must be done using the on-board jumpers and
gain controls described in Output Level Adjustments
on page 11 .
The following items will be reported under CH 3/4 INPUT STATUS :
■ CH 3/4 20/24-BIT MODE indicates whether Ch 3/4 are set for 20- or
24-bit operation at jumper J8 (Ch 3/4) on the circuit board. (Refer to
20/24-bit Operation
on page 11 .)
■ CH 3/4 BAL/UNBAL INPUT indicates whether Ch 3/4 are set for balanced 110
Ω or unbalanced 75 Ω inputs at the CH3/4 INPUT SEL jumper JP9 on
the circuit board. (Refer to Input Select on page 11 .)
■ CH 3/4 SAMPLE RATE indicates the current input sample rate being
detected by the module as one of the following: OUT OF RANGE , 32K , 32K
4% , 44.1K , 44.1K 4% , 44.056K, 48K or 48K 4% .
■ CH 3/4 INPUT ERROR indicates any input error conditions present as either
VALIDITY , CRC , PARITY, BI-PHASE , NO LOCK or NO ERROR .
■ CH 3 AND CH 4 LVL RANGE indicates whether Ch 3 and Ch 4 are set for HIGH
(19-24 dBu) or LOW (14-19 dBu) level range at jumpers JP2 (CH 3) and
JP1 (CH 4) on the circuit board. (Refer to Output Level Adjustments on
page 11 .)
■ CH 3 AND CH 4 DE-EMPH indicates whether de-emphasis is being applied
to Ch 3 or Ch 4 audio channel.
■ CH 3 AND CH 4 DATA indicates type of incoming data (audio or non-audio)
to Ch 3 and Ch 4 channels.
The CH 3/4 OUTPUT MODE display allows you to set the desired output mode
of the module from the selections listed in Table 7 on page 15 . After making
the selection, click the APPLY button to activate it.
Use
This
Link