EMU Australia E-MU LONGboard 61 - Manual (Page 14)

14 LONGboard 61 SHORTboard 49
Linking in Broadcasting Mode
Here’s how to link your Keyboard to one or more PIPElines in Broad-
casting mode.
Turn on your Keyboard. Turn on your PIPEline(s), the white LED 1.
will blink.
Setup Procedure
Connect the Audio
Set up the PIPEline audio outputs to headphones; an audio mixer; or •
integrated amp and speakers.
On the Rear Panel of your Keyboard
Use the Channel Select Knob to set the Channel Number. •
On each PIPEline
Set the CH switch to Ch1, Ch2, or Ch3 to match the Keyboard 2.
Channel Selector.
Set the B/P switch to the (-) position (Broadcasting mode).
3.
Set the R/T switch to the (-) position (Receive). 4.
Set the D/A switch to the (+) position (Analog). 5.
Link Procedure
On the Rear Panel of your Keyboard
Press the Connect button. •
On each PIPEline
Press the Link/Connect button. The white LED will stop flashing 6.
when connected.
Repeat the Link Procedure for each PIPEline.
7.
Play your Keyboard. You will hear audio from each PIPEline linked 8.
to your Keyboard.
If you change channels, the Keyboard and PIPEline will automatically •
re-link. (Of course, the Keyboard and PIPEline channels must match!)
If you turn off the Keyboard, PIPEline, or both; they will automatically •
re-link when you turn them back on.
You only have to perform the Link procedure again if you decide to link •
to a different PIPEline, or if you change Paired/Broadcast modes.