Ensemble Designs BrightEye 46 3G/HD/SD/ASI Electrical to Optical Converter - Manual (Page 5)

www.ensembledesigns.com BrightEye-5
3G/HD/SD/ASI Electrical to Optical Converter User Guide TM
BrightEye 46
REAR CONNECTORS
All connections to the BrightEye 46 are made on the rear of the unit. Refer to the illustration below.
CAUTION: This is a Class A Laser Product. The optical output emits invisible radiation. Do not
stare directly into the optical output beam or view directly with optical instruments.
BrightEye 46 Rear Connectors
Power Connection
Connect a modular power supply to the 12 volt DC power input connection on the far left of the unit.
Use the locking ring to secure it.
Optical Out
The optical output connector carries the same ITU-R 601 component digital television signal as a
directly modulated optical carrier in accordance with SMPTE 297M. It also conforms to high definition
and ASI specifications. The output wavelength is 1310 nm (nanometers), with a nominal output power
of -7 dBm. It is capable of driving both single mode (SM) and with an optical launch power attenuator
installed, multi-mode (MM) optical fiber. This is an LC type connector.
Input/Output BNCs
There are five rear BNC connectors which are used as follows:
3G/HD/SD/ASI In
Connect a 3G, HD, SD, or ASI video input to this BNC for distribution to the four BNC outputs and for
conversion to optical for outputting on the optical connector.
Out 1-4
Connect the four BNC outputs to the desired electrical video destinations corresponding to the correct
video input type.