Eneo F03Z06NDDC-MP - Manual (Page 4)

eneo ® is a registered trademark of Videor E. Hartig GmbH
Excl. distribution through specialised trade channels only.
VIDEOR E. Hartig GmbH
Carl-Zeiss-Straße 8 · 63322 Rödermark/Germany
Tel. +49 (0) 60 74 / 888-0 · Fax +49 (0) 60 74 / 888-100
www.videor.com
www.eneo-security.com
# 991154
Technical changes reserved.
© Copyright by VIDEOR E. Hartig GmbH 01/2012
Looking at lens connector:
3 1
2
III Connection
V Aspherical Lenses
When using the lens with B/W camera the
compensation filter and spacer must be used.
The compensation filter will be mounted on the
rear side of the lens. Install the spacer between
lens and camera.
Camera specifications should be observed for
lens balancing.
Damper coil
orange 1
yellow 2
red 3
black 4
Drive coil
IV Adjustment of the DC Control Lens
The switch should be set to „DC” if a convertible
camera is being used.
AUTOIRIS
VIDEO DC
Focus ring (manual)
C mount 1/2"
CS mount 1/3"
Cable length approx. 20cm 1
2
3
VI IR Function (for NFS Series)
The lens is designed to have the same focal
point in the IR light range as in the visible light
range. Since there is no focus shift in any light
condition, the lens is ideal for use with Day/Night
cameras. However, as the depth of field in the IR
range is very narrow, focus adjustment should
be done very carefully. So when you install the
lens with IR illumination, please check your focus
setting in both visible light and IR light.
A minor flange focus is possible between visible
light and IR light. If there is a day/night applica-
tion with IR illumination, the flange focus should
be set under IR light conditions. This is because
the iris is generally opened when used at night
due to the poor level of light and low depth of
focus. During the day, the iris is continuously clo-
sed further, there is a greater depth of focus and
a difference in the flange focus is compensated.