Eneo EDC-3371 - Manual (Page 28)

8
MOTOR SETUP
Motor Setup menu provides the pan and tilt speed of a camera. User can set the desired speed with twist the Joystick left or right. During operation,
pressing 153 + ON will change the speed to the SLOW mode and pressing 153 + OFF will change the speed to the Normal mode.
Holding and pressing CTRL and moving the joystick will operate with the TURBO speed mode.
MOTOR SETUP
PROPOTIONAL P/T: ON
P/T MODE: NORMAL
SLOW PAN MAXIMUM: 40°/SEC
SLOW TILT MAXIMUM: 40°/SEC
NORMAL PAN MAXIMUM: 90°/SEC
NORMAL TILT MAXIMUM : 90°/SEC
TURBO PAN MAXIMUM: 360°/SEC
TURBO TILT MAXIMUM: 00°/SEC
SAVE AND EXIT (ESC TO CANCEL)
PROPOTIONAL P/T ON / OFF
P/T MODE SLOW / NORMAL / TURBO
SLOW PAN MAXIMUM 9˚- 90˚/second
SLOW TILT MAXIMUM 9˚- 90˚/second
NORMAL PAN MAXIMUM 40˚- 360˚/second
NORMAL TILT MAXIMUM 40˚- 00˚/second
TURBO PAN MAXIMUM 00˚- 380˚/second
TURBO TILT MAXIMUM 90˚- 300˚/second
PASSWORD EDIT
ORIGIN CHECK
ARE YOU SURE ?
CANCEL
OK
PASSWORD EDIT SETUP
(CTRL KEY)
INPUT PASSWORD
PASSWORD:
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 3
4 5 6 7 8 9 ( )
SAVE AND EXIT (ESC TO EXIT)
You can change the password with 6-digit character in this menu.
The default password is 555555.
When the password enable is on, the input password window displays to enter the menu. At this time, move the cursor to the desired character by the
joystick and press CTRL or IRIS OPEN.
ORIGIN CHECK
When you find the wrong position of the dome during operation, execute this origin check and the dome camera will arrange the right position after the
origin check operation. Pressing 151 + ON will execute the origin check.