beautypg.com

Safety instructions, Connection 2. general, Installation and operating manual – Eneo HDC-1004M1080 User Manual

Page 5: Mounting

background image

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install
and commission the camera.
• Keep the manual in a safe place for later reference.
• Protect your camera from contamination with water and humidity to prevent it

from permanent damage. Never switch the camera on when it gets wet.
Have it checked at an authorized service center in this case.

• Never operate the camera outside of the specifications as this may prevent the
camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings. Operate the camera only at a temperature range of -10°C to +50°C
and at a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• Pay attention when laying the connection cable and observe that the cable is not

subject to heavy loads, kinks, or damage and no moisture can get in.

• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open.
This can destroy the sensor.
• Installation, maintenance and repair have to be carried out only by authorized
service centers. Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in accor-
dance with the technical data, e.g. by sealing of the cable outlet with silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.

NOTE: This is a class A digital device. This digital device can cause harmful

interference in a residential area; in this case the user may be required

to take appropriate corrective action at his/her own expense.

4. Connection

2. General

Main Features

• 1/3” 2.1 megapixels Progressive Scan CMOS sensor
• Resolution max. 1920 x 1080 (HD 1080p)
• 1.5G HD-SDI video transmission via coax cable
• WDR (Wide Dynamic Range)
• Integral motion detection
• RS-485 Communication (Pelco D)
• Digital zoom (0x - 20x)
• Privacy zones
• Supply voltage: 12VDC
• Compact board size (38x38mm)
• OSD control joystick

Parts supplied

Mounting bracket, screw set, connection cable set, manual

CAUTION !
• When you connect service video output cable, WDR function does not work.
• Service video output looks the angle of view narrower than HD-SDI output.

Installation and Operating Manual

1/3” HD-SDI Board Camera in Housing

with 3.7mm Lens
HDC-1004M1080

Camera

Mounting

bracket

Tapping screw:

∅ 3 x 8

Machine screw:

M2 x 2.5

CAUTION !
Please start installing in the order shown.

Service video connector

OSD Control joystick

Handheld monitor

HD-SDI

Power / RS 485

HD-SDI In

SDI
RECEIVER
DISPLAY
DEVICE

RS 485

Power jack (12VDC)

3. Mounting