Eneo NXB-980IR3516M - Manual (Page 22)

22
Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the
Setup>System> Maintenance web page (described in User’s Manual, “3.5.6
System > Maintenance”) or use the Reset button on the network camera, as
described below:
Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory
default settings using the Reset button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Remove the front cap of the camera.
3. Press and hold the Reset button while reconnecting the power.
4. Keep the Reset button pressed for at least 2 or more seconds.
5. Release the Reset button.
6. The network camera resets to factory defaults and restarts after com-
pleting the factory reset.
7. Close the front cap of the camera.
CAUTION: When performing a Factory Reset, you will lose any
settings you have saved. (Default IP 192.168.1.10)
Reset Button