Atlantic Water Gardens Pro Series FB4600 - Manual (Page 4)

1-877-80-PONDS
www.atlanticwatergardens.com
A ¾” sch40 PVC can be used as a standpipe and will enable the water to
bubble at the surface of the decorative piece. Standpipes should be cut
just below the surface of the water. Once the pipe is installed, seal any gaps
between the standpipe and the base of the pot with Atlantic SPSEAL and
place a few rocks around the pipe to stabilize it (Figure 5).
Cover the Fountain Basin with decorative material (ex. decorative gravel,
polished stones, glass beads, etc.) of your choosing to complete installation.
The final shape of the cover material does not need to be round and can
extend outside of the shape of the fountain basin if you desire.
Installation of a Fountain Basin in a Paver Patio or Walkway
The FB4600 and FB3200 Fountain Basin can be installed within a paver patio
or walkway. Recessed pockets allow 1½” conduit sleeves to be installed within
the radius of the basin. These sleeves allow access to the pump cords and low
voltage wiring when surrounding the basin with hardscape materials.
When setting the Fountain Basin within a paver patio, the top rim of the basin
should be set at least 1” lower than the top of the pavers. This will help retain
the decorative material after it is installed (Figure 6).
Figure 5.
Figure 6.