ARM Electronics ENDVR9A - Manual (Page 9)

5
1. POWER
Please use the provided adaptor to connect power cord (Other adaptor is not suitable for this machine).
2. EXTERNAL I/O
• Controlled remotely by an external device or control system.
• Alarm input, external I / O explanation.
3. 75Ω / HI
When using Loop function, please switch to HI. If you don’t use Loop function or disconnect the video
input, please set it as 75Ω.
4. VIDEO INPUT (1-9)
Connect to video source, such as camera.
5. CALL
Connect to CALL monitor. Show the Switch Display. When alarm trigger happens, the call monitor will show
the triggered channel for a period of time.
6. AUDIO OUT (R/L)
Connect to monitor or speaker.
• IPS should be set to 25A (for NTSC) or 18A (for PAL )
✻ with 2 mono audio outputs from the same source.
7. AUDIO IN (1-4)
Connect to audio source, such as microphone.
• IPS should be set to 25A (for NTSC) or 18A (for PAL)
✻ 4 audio inputs, but only can select 1 during recording.
8. MAIN
Connect to Main monitor
9. LOOP (1-9)
Connect video signal between Input port and Loop port to make a loop.
10. LAN
Connect DMR by network.
BACK PANEL
EXTERNAL I/O POWER 75Ω 2 CALL
LOOP
INPUT
R ISK OF ELE CTR IC SHOC K
D O N OT OPEN
WARNING : TO R ED UCE THE R ISK OF ELEC TRIC SHOCK,
D O NOT REMOVE C OVER (OR BACK). NO USER-SERVIC EABLE PARTS IN SIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
HI 1
MAIN
ACT
L 4
LINK
R 3
OUT IN
LAN
① ② ③ ④ ⑤
⑥ ⑦ ⑧ ⑨
⑩