ARM Electronics SDKBD1 User Manual
Page 7

- 4 -
1. Select Address of Speed Dome Camera /Decoder:[N]+[ CAM]
Description:N –– No. of camera from 0 to 64
Function:Select the address of the camera to be controlled. When the value N is in conformity with the
address of the speed dome, it will be under control.
2. To set preset position:[N]+[ PRESET]
Description:N –– No. of preset position from 1 to 64.
Function:Store current position and refer it as No. N position.
3. Call the Preset position:[N]+[ CALL]
Description::N –– No. of preset position from 1 to 64.
Function: Transfer the camera to the position of No. N preset position.
4. Cancel the Preset position: [N]+[CLEAR]
Description:N –– No. of preset position from 1 to 64.
Function:Delete the No. N Preset position stored.
5. Run patrol:[N]+ [SHOT]
Description:N –– No. of the track from 1 to 3.
Function:Tour the No. N track and stop tour by pushing the joystick.
6. To turn on Auto Pan (Operation of COP-2 SAMSUNG Protocol):[AUTO]+[P1]+[ON]+[P2]+[OFF]
Description:P1 –– the starting scan No. of preset point from 1 to 64, which should be set already.
Description:P2 – the ending scan No. of preset point from 1 to 64, which should be set already. If P1 =
P2 or P1 and P2 are coincided, the speed dome will make scan in range of 360°.
Note:
①
For PELCO-D、PELCO-P、COP-1 Protocol the way of operation is as follows:
Set the starting scan position: Transfer the Speed Dome to the starting scan position, operation
[AUTO]+[ON]
Set the ending scan position: Transfer the Speed Dome to the ending scan position, operation
[AUTO]+[OFF]
Run Auto Pan:[AUTO]+[SHOT]
②
Auto Pan operation takes the following parameters. You must set these parameters before using a
Auto Pan command to begin the scan operation. You can use the scan stop command or PT swing
stop command to stop the scan. Setting scan condition.
z Auto Pan Position (First specify position, second specify position)
z Auto Pan Speed and Direction
7. Stop Auto Pan:[AUTO]+[OFF] ( Only C0P-2 Available) or push the joystick to stop scan
8. Patrol setup (COP-1, COP-2, PELCO-D, PELCO-P Available):
a)
Set Patrol Start:[96] + [CALL] Begin to set the No.1 patrol,LED Display L1
[97] + [CALL] Begin to set the No.2 patrol,LED Display L2
[98] + [CALL] Begin to set the No.3 patrol,LED Display L3
b) Insert preset point in patrol:if LED display LN(N: No. of the patrol from 1 to 3.)you can insert
preset point in current patrol. Now you can operate as follow:
[N] + [CALL] (N: No. of preset position from 1 to 64). And you can insert 16 preset point in
maximum
c)
Set Patrol Stop: [99] + [CALL]
9. Control the zoom of the Camera:[WIDE]/[TELE]
10. Control the Focus of the Camera:[FAR]/[NEAR]
11. Control the Iris of the Camera:[OPEN]/[CLOSE]