ARAG Skipper LT - Satellite Navigator - Manual (Page 12)

12
5 Maintenance / diagnostics / rePairs
- Clean only with a soft wet cloth.
- DO NOT use detergents or aggressive products.
- DO NOT aim water jets directly at the navigator.
5.1 Troubleshooting
ProBleM cause solution
The display does not switch on No power supply • Check power supply connection.
No signal enabling treatment to
SKIPPER LT
Power cable improperly
connected • Check green lead connection to power
cable
(par. 4.7).
Improper set-up • Check set-up (par. 4.7).
Display shows message
The GPS receiver doesn't give
valid data
Wrong GPS antenna cable con-
nection • Check connection with GPS antenna
(par. 4.7).
Satellite connection in progress • Wait for connection to be established.
Display shows message
Differential correction not
available
DGPS signal not available in the
work area
• Disable DGPS.
DGPS connection in progress • Wait for connection to be established.
Tab. 1
6 technical data
Description SKIPPER LT
Display LCD 4", 65000 colors, 420 cd/m 2
Power supply 9 - 15 Vdc
Working temperature
0 °C ÷ 45 °C
+32 °F ÷ +113 °F
Storage temperature
-20 °C ÷ 60 °C
-4 °F ÷ +140 °F
Weight 550 g
1 USB 1.1 port HOST
Treatment input Active high (+12 Vdc)
Tab. 2
7 disPosal at the end of service
Dispose of the system in compliance with the established legislation in the country of use.