Aquatic AV AQ-AD300.2 - Manual (Page 8)

USER GUIDE
8
www.aquaticav.com
AQ-AD300.2
CONNECTORS & CONTROLS
The images below list the controls and connectors of the AQ-AD300.2 amplifier.
High Level (Speaker) Input connector
This connector allows the amplifier to use speaker outputs from a Source Unit as inputs
to the amplifier.
Colors for High Level Input Wires:
Low Level Input connector
This connector allows the amplifier to use industry standard RCA outputs, from a
standard source unit, as inputs to the amplifier. This is the preferred method when RCA
outputs are available and will produce the cleanest source signal to the amplifier.
CONNECTORS DEFINED
To save on space an industry standard 3.5mm headphone style jack is used on the amplifier
(1x 3.5mm jack sockets is a lot smaller than 2x RCA sockets). Although we highly recommend
using the Low Level input cables supplied with the AQ-AD300.2 amplifier.
High Level (Speaker) Input Wires
Left + White
Left - White with Black strip
Right + Grey
Right - Grey with Black strip
A INPUT GAIN ADJUST E AMPLIFIER PROTECTION FUSE I CROSSOVER FILTER ADJUST
B HIGH LEVEL INPUTS F POWER & STATUS LED J HIGH / LOW LEVEL INPUT SWITCH
C SPEAKER OUTPUTS G LOW LEVEL INPUT K HIGH / LOW PASS FILTER SWITCH
D POWER & GROUND TERMINALS H REMOTE TURN-ON TERMINALS
A
J I
B C
H
G F D E
K
These wire colors correspond
to an Aquatic AV Source Unit
harness. If using a High-Level
source other than from Aquatic
AV, these colors could vary.