Aquatic AV AQ-AD300.2 - Manual (Page 7)

INSTALLATION
7
www.aquaticav.com
AQ-AD300.2
5. Install 4 Ohm or 2 Ohm speakers of your choice, if they are not already installed.
6. Route and connect the speaker wires from each speaker of your system to the cor-
responding speaker output terminal block on the amplifier (right/left).
Keep the polarities (+/–) of each wire pair correct between the amplifier(s) and
speakers.
7. Re-connect the positive (+) side of the battery, followed by the negative (-) side.
Do not install the in-line fuse until after this step. This is a good time to re-check
your connections before installing the fuse. Make sure that all control cables are
completely seated and latched in their respective connectors, and that power and
ground are properly connected to the main amplifier.
8. Install the 25 amp ATC fuse into the in-line fuse holder on the power wire.
9. Perform a basic system test, verifying that the amplifier(s) power up (led on each
component should light) and that the speakers function properly. If not, proceed directly
to Troubleshooting in the User Guide section.
10. Configure, test, and tune your system by following the Test and Tune instructions
given in the User Guide section of this manual. When you’ve completed these instruc-
tions the installation is complete.
WIRING THE SPEAKERS
TESTING & TUNING THE SYSTEM