Donning and adjustment procedures – Aqua Lung Pearl BC User Manual
Page 16
English
© 2012 Aqua Lung International
DONNING AND ADJUSTMENT PROCEDURES
1. Remove the weight pouches from the BC, if applicable.
2. Disconnect the waist buckle and waistband.
3. Ensure that the quick release buckles (if equipped) on both torso straps are securely fastened.
While firmly holding the torso strap where it connects to the BC lobe, fully extend each torso strap
to its maximum length by pushing straight up on the slide buckle.
4. While your dive buddy lifts and holds the BC/cylinder behind you, place your arms through the BC
torso straps as if you were putting on a jacket.
5. While your dive buddy lifts and holds the BC/cylinder behind you, place your arms through the BC
torso straps as if you were putting on a jacket.
6. Connect the chest strap buckle. Pull on the free end of the strap to tighten. The chest strap should
feel comfortable across the chest; it should not be overtightened so that it feels restrictive.
7. After your buddy has released the cylinder and the BC feels comfortably supported on your hips and
shoulders, bend forward at the waist and adjust the torso straps to a comfortable length by pulling
on the torso strap D-rings (if equipped).
8. If necessary, readjust the waistband and waist buckle so that they are comfortably snug, but not
restricting.
NOTE:
Adjusting the shoulder straps too tightly will transfer the cylinder weight from the hips
to the shoulders, restricting your arm movement and decreasing comfort.