Aqua Leisure Steel-Set Pool - Manual (Page 5)

P.5
1. SITE SELECTION
Proper site selection is the most critical part of the installation process. Make sure that
your chosen area strictly conforms to the following guidelines. The set-up area must be:
A. Firm, flat (no bumps or mounds of earth) and level. WARNING: Failure to install the
pool on a firm, level surface may cause the pool to leak, bulge, or even collapse,
resulting in property damage or serious injury for those in or near the pool! If you must
level out an uneven set-up area, it is preferable to dig out excess earth, boulders, etc.
from the higher side. Once the excess earth has been removed, tamp down the whole
area to ensure levelness. Remember NOT TO USE SAND with this type of pool.
B . Completely free of sticks, stones, blacktop, oil-based residues, sharp objects, and aggres-
sive grass, plant and weed species. NOTE: Aqua-Leisure will not be held responsible for
damage caused by aggressive grasses or weeds that grow up through the pool.
C. Not directly underneath overhead power lines or trees, nor atop any underground utility
cables, pipes, or lines of any kind. CAUTION: The pool must be accessible to a 110-volt
AC outlet protected by a Ground Fault Circuit Interrupter (GFCI), and should be set no
closer than 10 ft / 3m to the power source.
Additional helpful tip: Choosing a set-up area exposed to direct sunlight will warm your pool
more quickly and keep it warmer throughout the season.
2. PARTS REFERENCE
Before assembling your Steel-Set™ Pool, layout and review the contents to become familiar
with all the parts you will be using during the assembly:
STEEL-SET ™ FRAME POOL SET-UP INSTRUCTIONS
ATTENTION: DO NOT PROCEED UNTIL YOU HAVE COMPLETELY
READ THE SAFETY RULES ON PAGE 4.
Horizontal Beam
Larger diameter pole with one pin on each end
Vertical Leg
Smaller diameter pole with two pins at one end
T-Joint Leg Cap
A A
A A
B B
C C
C C
D D
D D
B B