Elmo TSE270X - Manual (Page 3)

- 2 -
PRECAUTIONS FOR USE AND INSTALLATION
* Never aim the camera at the sun.
Never aim or point the camera at the sun even if you are
not shooting.
* Do not shoot intense light.
Strong light such as a spot light on the image plane will
cause blooming or smear. When strong light comes into
the image plane, vertical stripes may appear on it.
However, this does not mean that the camera is defect.
* Take precautions when handling a camera.
Do not drop your camera, or give it a strong shook or
vibration. This may cause camera to malfunction.
* Do not touch internal parts.
Be sure not to touch the internal parts. This may cause to
electrical shock.
* Do not let the camera get wet.
Install the camera at the place where it will not get wet.
Should it gets wet, turn off the power immediately and
contact your dealer.
* Install your camera where no video noise appears.
When camera cables have been laid near electric wires or
television receivers, a noise may interfere the image.
If noise occurs, relocate cables or reinstall equipment.
* Check the ambient temperature and humidity.
Avoid using camera in areas where temperature is
consistently hotter or colder than the specified range (See
Specifications chart below) or poor image quality or
damaged parts may occur.
Precautions should also be taken to avoid areas of high
humidity.
* Should you notice any trouble.
If any trouble occurs while you are using the camera, turn
off the camera and contact your dealer. Failure to do so may
cause damage to the camera.
* The socket-outlet should be installed near the equipment
and should be easily accessible.
SPECIFICATION
Power source
Power consumption
Pick-up device
Effective picture element
Scanning area
Scanning system
Scanning frequency(H)(V)
Sync. system
Resolution
S/N ratio
Recommended illumination
AGC
Sens-up
Backlight control
AES
(Automatic Electronic Shutter)
Gamma correction
Accumulation node
Output signal
Auto-iris terminal
Power terminal
Lens mount
Ambient temperature
Ambient humidity
Dimensions
Weight
AC24V ± 10% 60Hz ± 1Hz
Approx.6W
1/3" Black & White interline-transfer CCD
512 (H) X 492 (V)
4.92mm (H) X 3.69mm (V)
2:1 interlaced
15.75Hz 60Hz
Line-lock
380TV lines (Horizontal) 350TV lines (Vertical)
More than 46dB
22 lx (F1.2 under incandescent lamp)
Built into camera circuitry
Provided (Factory-set at OFF)
Provided (Factory-set at OFF)
Provided (Factory-set at OFF)
0.45
Field
VBS 1.0 Vp-p, 75 Ω, EIA, compatible
4P (DC/Video)
3P terminal
CS
-10 °C ~ +50°C (14°F~122°F)
30% ~ 90%
60(W) X 60(H) X 120(D)mm (2.4 X 2.4 X 4.9 inches)
510 grm (1.13 lbs)
Model TSE270X TSE271X
DC12V (DC11V-16V)
Approx.3.2W
15.734Hz 59.94Hz
Internal
2P terminal
320 grm (0.71 lbs)
TSE272X
AC120V ± 10% 60Hz ± 1Hz
Approx.6W
15.75Hz 60Hz
Line-lock
Power cord
600 grm (1.32 lbs)
Note: Weight and dimensions are approximate.
Design and specifications are subject to change without prior notice.