Electrolux 40036VI-WN - Manual (Page 4)

• Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch the
hob surface if you move them on the surface.
• Discoloration of the enamel has no effect on the performance of the appliance.
• To prevent damage or discoloration to the enamel:
– do not put any objects directly on the appliance floor and do not cover it with alumi-
nium foil;
– do not put hot water directly into the appliance;
– do not keep moist dishes and food in the appliance after you finish the cooking.
• Do not apply pressure on the open door.
• Do not put flammable materials in the compartment below the oven. Keep there only
heat-resistant accessories (if applicable).
• Do not cover oven steam outlets. They are at the rear side of the top surface (if applica-
ble).
• If there is a crack on the surface, disconnect the power supply. There is a risk of electric
shock.
• Do not put heat-conducting materials (e.g. thin metal mesh or metal-plated heat con-
ductors) under the cookware. Excessive heat reflection can damage the cooking surface.
Care and cleaning
• Before maintenance, make sure that the appliance is cold. There is a risk of burns. There
is a risk that the glass panels can break.
• Keep the appliance clean at all times. A build-up of fats or other foodstuff can result in a
fire.
• Regular cleaning prevents the surface material from deteriorating.
• For your personal safety and the safety of your property, only clean the appliance with
water and soap. Do not use flammable products or products that can cause corrosion.
• Do not clean the appliance with steam cleaners, high-pressure cleaners, sharp objects,
abrasive cleaning agents, abrasive sponges and stain removers.
• If you use an oven spray, follow the instructions from the manufacturer. Do not spray
anything on the heating elements and the thermostat sensor.
• Do not clean the glass door with abrasive cleaning agents or metal scraper. Heat resist-
ant surface of the inner glass can break and shatter.
• When the door glass panels are damaged they become weak and can break. You must
replace them. Contact the service centre.
• Be careful when you remove the door from the appliance. The door is heavy.
• Bulb lamps used in this appliance are special lamps selected for household appliances use
only. They cannot be used for the full or partial illumination of a household room.
• If it becomes necessary to replace the lamp use one of the same power and specifically
designed for household appliances only.
• Disconnect the appliance from the power supply before the replacement of the oven
lamp. There is the risk of electrical shock. Cool down the appliance. There is a risk of
burns.
Installation
• Only an approved technician can install and connect the appliance. Contact an approved
service centre. This is to prevent the risks of structural damage or physical injury.
• Make sure that the appliance is not damaged because of transport. Do not connect a
damaged appliance. If necessary, contact the supplier.
4 Safety information