Amer Networks SR24G2 - Manual (Page 13)

7
Figure 3. Mount the Switch in the rack
Connecting Network Cable
The Switch supports 10/100/1000Mbps Gigabit Ethernet. It runs full/half duplex
transfer mode for 10/100Mbps and full duplex transfer mode for 1000Mbps.
These ports are Auto-MDI type. The Switch can auto configure to MDI-II or MDI-X
type, so you can make a connection without worrying if you are using a standard or
crossover cable.
AC Power
The Switch can be used with AC power supply 100~240V AC, 50~60 Hz. The power
switch is located at the rear of the unit adjacent to the AC power connector and the
system fan. The switch’s power supply will adjust to the local power source
automatically and may be turned on without having any or all LAN segment cables
connected.