Amer Networks SD8N - Manual (Page 23)

14
speed.
2. The FDX 10/100, COLL 10/100 LED indicator
depends upon LAN card capabilities for full-
duplex or half-duplex.
Hub to Switch
A hub (10 or 100BASE-TX) can be connected to the
Switch via a two-pair Category 3, 4, 5 UTP/STP
straight cable (Cat.5 must be used for 100Mbps). The
connection is accomplished from the hub uplink (MDI-
II) port to any of the Switch (MDI-X) ports: 1x - 8x for
the 8-port 10/100 Fast Ethernet Switch.
A. 10BASE-T Hub
For a 10BASE-T hub, the Switch LED indicators
should light up as the following:
1. FDX 10/100, COLL 10/100 LED indicator is
OFF.
2. 100LINK/ACT, 10LINK/ACT LED indicator is
lit amber.
B. 100BASE-TX Hub
For a 100BASE-TX hub, the Switch LED indicators