Emerson Radio CK5238 - Manual (Page 7)

6
OPERATING INSTRUCTIONS
SETTING THE CLOCK
When you connect the radio to your AC outlet for the first time the clock display
will begin flashing “12:00” (AM). The flashing will stop when you set the time.
1. Depress the Clock button and either the Fast Forward or Fast Reverse
buttons to rapidly move the time display forward or back.
2. As the display approaches the correct time release fast setting buttons and
depress the Slow Forward
or Slow Reverse buttons until the correct time
appears, then release all buttons.
Note: Be sure to observe the AM indicator to make sure that the time is set
correctly for AM or PM. If the AM indicator is ‘on’, the time displayed is “AM”. If
the AM indicator is ‘off’, the time displayed is “PM”.
SETTING THE WAKE UP TIMES
This clock radio has two separate alarms that can be set and used independently.
You may use the alarms to wake two people at different times, or you may use
one alarm for weekdays and the other for weekend wake up times. The procedure
for adjusting the wake up time is the same for both Alarm 1 and Alarm 2.
1. Depress and hold either the Alarm 1 or Alarm 2 setting button. The display
will change from the correct time to the Alarm 1 or Alarm 2 wake up time.
2. While holding the Alarm 1 or Alarm 2 setting button, depress either the Fast
Forward or Fast Reverse button to move the display rapidly ahead or
back.
3. As the display approaches your desired wake up time, release fast setting
buttons and depress the Slow Forward or Slow Reverse buttons until the
desired wake up time appears, then release all buttons.
Note: Be sure that you have set the wake up time correctly by observing the AM
indicator. If the AM indicator is ‘on’ the wake up time is “AM”. If the AM indicator
is ‘off’, the wake up time is “PM”.
AM indicator
ALM 1(ALARM 1)
indicator
ALM 2(ALARM 2)
indicator