Allmand Brothers PAL4000 - Manual (Page 14)

14
OPERATION
LIGHT FIXTURE ADJUSTMENT
WARNING! BURN HAZARD. The light
fixtures become extremely hot during
use. Always use caution and heat re-
sistant gloves when handling the
lights or allow the lights to cool suffi-
ciently before handling.
The light fixtures must be adjusted to the de-
sired work angle before raising the tower.
With the tower fully lowered and the lights off,
the light fixtures can be rotated to the desired
working position.
To adjust each light fixture, manually swivel
each light fixture at its base into the desired po-
sition.
GRAB LIGHT FIXTURES
HERE TO ADJUST
LIGHT FIXTURE STOWAGE
Your light tower may be equipped with lights
that can be removed for stowage or for theft
prevention.
WARNING! BURN HAZARD. The light
fixtures become extremely hot during
use. Always use caution and heat re-
sistant gloves when handling the
lights or allow the lights to cool suffi-
ciently before handling.
1. Ensure lights are off and tower is lowered to
the full down position.
2. Disconnect the electrical cord from each
light.
3. While supporting the light fixture, remove
the nut and washer assembly fastening the
main fixture bracket and remove each light
fixture and bracket.
4. Store each light fixture to avoid any damage
or theft.
LIGHT CONTROLS
The four lights are controlled and protected by
four breaker switches located on the side of the
ballast box.