Allmand Brothers I HYDRAULIC - Manual (Page 13)

13
SPECIFICATIONS
ELECTRICAL
Hard wired electrical circuits
Componentized ballast assemblies
Ground rod
Hour meter
Voltmeter (optional)
External 120V and 240V outlets (optional)
FLOOD LIGHT ASSEMBLY
Four or six 1000 watt lamp fixtures sealed for
all weather use. Lamps can be either the SHO
1000 fixture, 1250 watt fixture or PowerLite
fixture.
SHO 1000 FIXTURE - BT-37 lamp, Metal
Halide, Laboratory rated life is 10,000 hours.
Lumen rating: 110,000
Warm-up time: 2-4 minutes
Restart time: 10-15 minutes
POWERLITE FIXTURE - BT-56 1000 watt
Multi-Vapor lamp, Metal Halide, Laboratory
rated life is 12,000 hours.
Lumen rating: 110,000
Warm-up time: 2-4 minutes
Restart time: 10-15 minutes
POWERLITE FIXTURE - E-25 1000 watt
High Pressure Sodium lamp (often referred to
as H.P.S), Laboratory rated life is 24,000
hours.
Lumen rating: 140,000
Warm-up time: 4-6 minutes
Restart time: 1 minute
NOTE: A trailer equipped with Metal Halide
lights and a trailer equipped with High Pres-
sure Sodium lights use different ballasts and
starters. Therefore, it is not advisable to
interchange bulb types.
MAST
1. A single stage hydraulic cylinder inside
the cabinet raises the tower from the
horizontal towing position to vertical.
2. A three-stage telescopic hydraulic
cylinder supported inside a steel tube
mast extends to raise the lights to 30
feet.
3. Hydraulic power is provided by a self-
contained 12 volt hydraulic power unit
operated by two switches located on the
control panel.
TRAILER
The complete generator is housed in a
lockable enclosure with the frame fabricated
from heavy gauge steel mounted on a two-
wheel, leaf spring axle. The design enables
the trailer to contain the outriggers in a
simple compact position.
When the mast is in the operating position it
is located in the middle of a four point
outrigger system for optimum balance and
stability. This system was engineered to
allow the light plant to remain operational in
sustained winds of 65 MPH with the mast
extended to full height and the outriggers in
position.
The design includes an adjustable-height re-
versible hitch, which includes a 2” ball and
pintle hook hitch.
STABILIZERS
Four (4) point outrigger design with tower
center mounted between two (2) retractable
side outriggers, tongue and rear jack.