Allmand Brothers I HYDRAULIC - Manual (Page 11)

11
SPECIFICATIONS
See the KUBOTA 905 EBG1 or 1105 EBG1 Engine Operators Handbook or
the PERKINS 103-10 Engine Operators Handbook for information on
oil and fuel requirements.
TOWING INSTRUCTIONS
Before towing the MAXI-LITE the trailer should be inspected visually to insure that
the following operations have been completed.
1. Hitch is securely attached to towing vehicle (safety chain secure).
2. All outriggers and jacks are retracted and secured.
3. Tower is lowered and the rear tower support pin is in place.
4. Light fixtures are positioned for transport.
5.
6.
7. Taillights are connected and operating (if equipped).
8. Ground rod is removed from ground and secured in the trailer.
GROUND ROD INSTRUCTIONS
1. Remove ground rod stowed inside the left door (attached to the lower frame).
2. Unroll the electrical wire lead from the ground rod.
3. Attach the ground rod lead to the grounding lug located near the ballast compartment.
4. Drive the ground rod a minimum of 2 1/2 FT into the earth for adequate electrical grounding. If
this is not possible consult your local qualified electrician.
5. After shutdown of engine: Remove the ground rod from the earth, remove lead from the trailer
ground lug and store ground rod inside left door.
Check for adequate tire pressure.
Doors are closed and secure.
KUBOTA D905, D1105, AND PERKINS 103.10
FUEL AND LUBRICATING OIL REQUIREMENTS