Alinco EJ-50U - Manual (Page 21)

21
Command/Response
[C] command
[R] Response
Sequences
[Rn] Receiving sequences. n=0-7
[Sn] Transmitting sequence n=0-7
4-7-3 MCON
command
Abbrev. MC default OFF parameters: ON/OFF
Example: MC ON
This allows you to monitor frequency activity even when connected to another station.
ON allows you to monitor while you are connected. OFF does not.
4-7-4 MALL
commands
Abbrev. MA default: ON parameter: ON/OFF
Example: MA ON
When ON, all stations will be monitored, connected and unconnected. When OFF, it does not monitor stations
that have sent unproto data such as a CQ call.
4-7-5 MRPT
command
Abbrev. MR default: ON parameter: ON/OFF
Example: MR ON
This is to determine if you wish to display relay station (digipeater) information in the header or not.
If ON is selected, the relay list will be shown with [*]. OFF excludes such information.
4-7-6 TRACE
command
Abbrev. TRAC default: OFF parameter: ON/OFF
Example: TRACE ON
When ON, it will display all the details of the frame. The left side block shows frames in 16-digit codes. The
right side block shows them in ASCII codes. The display system may differ from that of a conventional TNC
when the EJ-50U is used.
4-7-8 MSTAMP command
Abbrev. MS default OFF range ON/OFF
example MS ON
When On, adds date/time on the monitored frame header.
ON: When the date and time has been set using the DAYTIME command, the date and time will appear.
OFF: Packet is displayed without date and time.
5. To connect to a GPS
5-1 What does it do with GPS?
GPS, the Global Positioning System, transmits signals from a constellation of GPS satellites orbiting the earth.
A GPS receiver uses data from these satellites to determine the current geographical position of the receiver. This
system is widely used in navigation today. The EJ-50U can transmit the position data taken from the GPS receiver
at pre-determined intervals. This feature allows you to set up a mobile location system, such as a car-navigation
system and/or APRS operations.