Airlink APSUSB2 - Manual (Page 7)

Network Cable Connector
The Print Server’s rear panel features an RJ-45 connector for connection to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which should be Category 5 twisted-pair cable). The port
supports the NWay protocol, allowing the print server to automatically detect or negotiate the
transmission speed of the network.
DC Power Connector
The DC power input connector is located on the Print Server’s rear panel and is labeled DC 5V
LED Indicators
The front panel of the Print Server features five LED indicators:
Power Link/Act USB LPT1
LPT2
Front Panel LED Indicators
♦
Power
◊
Steady or flashing green confirms that the Print Server is powered on.
♦
Link/Act
◊
Steady or flashing green confirms that the Print Server has a good connection to the
Ethernet or Fast Ethernet network.
◊
The indicator blinks off briefly to indicate that the Print Server is receiving or
transmitting from the network.
♦
USB, LPT1 , LPT2
◊
These LED indicators light to show that the Print Server is transferring print data
through the appropriate parallel port or USB port .
These three indicators are also used by the print server’s power-on self test (POST) to
indicate any hardware failures.