ACTi ACM-7411 - Manual (Page 21)

2-15
2.5 How to Do the Waterproof
Installation
The following installation procedure makes the camera be water-resistant even for the
situations where the camera can easily be flooded by pouring rain.
The important part to focus on during the installation:
The protection of the cabling has to be done by a proper
flex conduit. The size of the flex conduit that matches
with the conduit gland is is 3/4” (trade size), or with
actual physical diameter of 26.441mm.
Have the Ethernet cable inserted through the
flex conduit together with RJ-45 connector.
You may also consider to do the RJ-45
connector crimping after pushing the cable
through the conduit.
Disassemble the conduit gland.
Slide the clamping nut around flex conduit some
10-20 cm away from the top. Fit the sealing insert
(made of rubber) to the top of the flex conduit.
On the camera side, decide which of the 2 possible holes you are going to use to
connect the flex conduit. There is one hole on the side, and one on the bottom.
Whichever you pick, remember to seal off the other one with the metal patch
(included in the camera set).