ACTi Indoor Dome (D5xE5x) on Dropped Ceiling with Flush Mount - Manual (Page 3)

www.acti.com
Installation Guide
3
Installation Procedures
This section describes the procedures in installing the camera discretely above the ceiling using
Flush Mount. For simplicity, most of the camera images used in the succeeding sections were
taken using the camera model with heat sink; same procedures apply to the model without heat
sink unless specified.
Step 1: Prepare for Installation
1. Prepare the following accessories and tools for installation:

Flush Mount (PMAX-1006)

Phillips Screwdriver

Network Cable

Hole Saw (or similar for drilling a hole)
2. Drill a 184-mm diameter hole on the ceiling where you want to mount the camera.
3. Route the network cable through the hole on the ceiling.