ACTi Indoor PTZ on Straight Wall with Wall Mount - Manual (Page 3)

www.acti.com
Installation Guide
3
Installation Procedures
To install the camera on a straight wall, use the L-Type Wall Mount. The camera will be facing
down as if installed on a ceiling.
NOTE: The L-Type Wall Mount is not included in the camera package. Contact your sales agents
to purchase.
Before installation, prepare the following:
L-Type Wall Mount Package Other Tools (not supplied)

L-Type Wall Mount

Drill template

Screws (3)

Phillips screwdriver
Step 1: Install the L-Type Wall Mount
1. Use the drill template (included in the L-type wall mount package) to mark and drill the
mounting holes on the wall.
2. Route the network cable and other cables (if any).
NOTE:

Other cables refer to cables of an external power adapter, audio input/output and
digital input/output devices.

To illustrate how to connect other device cables to the camera, the following images
show the cable of an external power adapter (not included in the package). Same
cable routing applies to other devices. To connect a power adapter or a digital
input/output device, the bundled terminal block must be attached to the cables. For
more information on connecting the terminal blocks, refer to the camera model
Hardware Manual downloadable from the website ( www.acti.com ).