ACTi Indoor Dome on Tilted Wall - Manual (Page 4)

www.acti.com
Installation Guide
4
Step 2: Open the Dome Cover
NOTE: To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retain
the plastic covering the dome cover until the camera is completely installed.
1. With the bundled hex screwdriver, loosen the three (3) screws securing the dome cover.
2. Lift to remove the dome cover.
3. If the cables will be routed along the surface, remove the cable tab from the dome cover.
4. If the cables will pass through the surface, route and pull the cables through the hole on
the surface.