ACTi Indoor Mini Dome and Mini Fisheye Dome on Tilted Wall - Manual (Page 3)

www.acti.com
Installation Guide
3
Installation Procedures
This section describes the procedures in installing the camera directly on the wall. Prepare a
screwdriver and network cable for this installation; no additional accessories are required.
NOTE: For simplicity, the camera with fixed lens was used to take the images in the succeeding
sections; similar procedures apply to the other models in terms of installation. Therefore, the
camera images used in the succeeding sections may differ from your camera.
Step 1: Prepare the Camera
1. Using the bundled hex screwdriver, loosen the three (3) screws to remove the dome cover.
2. If the network cable will be routed along the surface , slide the cable exit tab from the
dome cover. Otherwise, skip this step.