Installing the camera on a surface, E 13 – ACTi D91 User Manual
Page 13
Hardware Manual
Installing the Camera on a Surface
1.
Mark the location of the screw holes base on the drill template included in the package.
NOTE:
Depending on the surface where you will install the camera, it may be necessary to
drill three (3) holes with
φ
3.5 on the ceiling and use the supplied screw tox.
2.
Route the cables through the ceiling, taking the Conduit Hole on the drilling template as a
reference. Or, slide off the cable exit tab on the dome cover to route the cable through that
hole later.
Conduit Hole