ZeeVee HDbridge 2312 (DVB-T/C) - Manual (Page 5)

HDbridge 2312-EU Configuration Guide
|
Page 5
Factory default settings allow HDb2312
series modulators to broadcast up to 12SD
sources on RF channels 21, 22, 23, 24, 25,
and 26 for reception at connected HDTVs.
We recommend using the most updated
version of firmware. You can find the latest
version on the Support section of our
website.
Beginning setup
1. Apply power.
2. Connect a Composite Video source to any
Composite Video Input of the HDb2312.
3. Connect the Analog Audio.
Tuning your channel at the HDTV (Auto Scan)
1. Connect the Coaxial Output of the
HDb2312 to your RF network. If the RF
power for your network is too high, you
will observe video breakup.
2. Set the RF Input on the TVs to DVB-T
(default) or DVB-C with the Symbol Rate
6740 KS/sec.
3. Enter the RF number to tune directly to
the channel. For default channel lineup
information, refer to the Default Channel
Lineup table. If you cannot tune directly to
the channel at this point, it is because most
TVs will require you to run a full Auto Scan.
4. Run the Auto Scan through the menu
system of your HDTV to find the channels.
Basic Installation
DEFAULT CHANNEL LINEUP
DVB-T Factory
Defaults
Logical
Channel #
Ch. 21 (474 MHz) 1 2
Ch. 22 (482 MHz) 3 4
Ch. 23 (490 MHz) 5 6
Ch. 24 (498 MHz) 7 8
Ch. 25 (506 MHz) 9 10
Ch. 26 (514 MHz) 11 12
Optional DVB-C
Channel Plan
Logical
Channel #
Frequency 85 MHz 1 2 3
Frequency 93 MHz 4 5 6
Frequency 101 MHz 7 8 9
Frequency 109 MHz 10 11 12
Video Source
Back of HDb2312 Modulator
RF Output
+45 dBmV
Analog
Audio
Composite
Video
Composite
Video Source
Ethernet to network or
directly to computer
Optional Delay Matched
Analog Audio Out to
audio system
WARNING: +45 dBmV
Do not connect directly to HDTV
Coax cable connects
to coax network