Electrolux Z8800 Series - Manual (Page 13)

HOW TO
MAINTAIN cont.
Caution: Make sure
On/Off switch is in
Off (o) position and
power supply cord
is unplugged before
replacing belt. Belt
pulley can become hot
during normal use. To
prevent injury, avoid
touching the motor shaft
when checking the belt.
Maintain
Brushroll
Remove hair and
threads from brushroll
periodically. For best
cleaning bristles must
touch carpet, if worn
down replace brushroll.
Note: Do not remove
endcaps from brushroll.
Maintain
Brushroll Belt
* Part Number ZE096
Note: Turn off the switch
and unplug the electrical
cord before replacing belt.
Belt pulleys can become
hot during normal use.
To prevent injury, avoid
touching the motor shaft
when checking the belt.
1) Use foot pedal to lower
handle; lay vacuum
flat on ground.
2) Turn vacuum over
3) Remove 4 screws.
Turn vacuum back
over (dust cup faces
ceiling) and remove the
hood of the vacuum.
4) Remove brushroll
and belt.
5) Thread new belt
around motor shaft
then brushroll.
6) Insert left end of brush-
roll first, then right end.
HOW TO
MAINTAIN cont.
7) Make sure brushroll
is completely in
compartment. Rotate
brushroll 2 turns
to center belt.
8) Replace hood & turn
over (dust cup facing
floor). Screw in the 2
screws closest to the
brushroll first - this
will help align the 2
screws on the rear of
the base. Screw in the
2 screws in the rear.
13