Electrolux Z8800 Series - Manual (Page 11)

HOW TO
MAINTAIN cont.
3) Check the HEPA
EF105 Exhaust Filter:
Empty the dust cup
and do not place it
back in the vacuum;
lay the vacuum flat on
the floor. The HEPA
filter is accessed by
removing the foam
filter & frame, and
turning the knob
left. Remove the
HEPA filter door
completely, and brush
off or replace the
HEPA filter. Place
the HEPA filter into
the chamber, lay the
filter door in place
& turn the knob to
the right to secure it.
Place the foam filter
& frame and the dust
cup back in place, and
lock the dust cup.
Important: Arm &
Hammer deodorizing
patches are NOT
washable.
HOW TO
MAINTAIN cont.
Caution: Make sure
On/Off switch is in Off
(o) position and power
supply cord is unplugged
before servicing.
Clean and
Replace Filters
* Part Number Foam
Filter EF106
Note: The filter screen
is located directly
above the dust cup.
1) Clean the Filter Screen:
The filter screen is
easily removed by
turning it counter-
clockwise. It should
be checked monthly to
ensure an open airway.
Reinsert the screen by
turning it clockwise.
2) Clean the Foam
Filter: The foam filter
is located beneath the
dustcup and is easily
accessed by lifting
the access door. It is
normal for this filter
to collect dirt & debris
and should be cleaned
regularly depending on
vacuuming frequency.
Remove the foam
filter & frame; remove
excess dust foam by
shaking or brushing
it into a waste basket.
The foam filter & filter
frame can be hand
washed (do not wash
in a dishwasher) under
warm water. Once the
foam filter & filter frame
are THOROUGHLY AIR
DRIED, place them
back into the vacuum
before the next use.
11