Widex SCOLA FLEX - Manual (Page 12)

12
The scan button
By using the channel scan button:
Press the scan button down. The receiver will then scan
the pre-selected channels automatically. During scan-
ning, a brief beep will be heard every 1½ seconds.
When an FM signal is detected on one of the channels,
the scanning stops automatically and two beep tones
are heard. If no FM signal is detected on any of the pre-
selected channels, the scanning will not stop until all
channels have been scanned, i.e. it will return to the
starting channel. A long beep will then be heard.
The hearing care professional can change the channel
scan button function so that it is no longer possible to
operate the scan button. The scan button setting can
be noted at the back of these instructions.
The frequency and volume of the beep tone can also be
adjusted by the hearing care professional.
By synchronising:
SCOLA CLASSMATE, SCOLA TEACH or other compat-
ible products can wirelessly set the SCOLA receiver to
a specific receiving channel.