Widex T-Dex - Manual (Page 4)

4
Wireless setup for mobile telephone
Establishing a wireless connection between the Bluetooth mobile telephone and the T-DEX
1. Turn T-DEX on by holding down the receiver button R1 for up to five seconds.
2. Enter the mobile telephone menu to allow the mobile telephone to search for available Bluetooth devices.
3. Select the Bluetooth entry “T-DEX”.
4. Enter the pass code into the mobile telephone (0000). Select connect. A short beep will be heard in the
hearing aid or in the headphones.
5. Once the wireless connection is established, receiver indicator R3 stops blinking blue.
R3
Please note:
• Once a wireless connection between T-DEX and a
Bluetooth unit has been established the units will
automatically connect when they are within range of
each other.
• During telephone conversations, the receiver indicator R1
will illuminate blue indicating that the wireless connection
is active.
Neck loop and T/MT function on HA
In order to use T-DEX with hearing aids in T-position (telecoil), the hearing aid must be equipped with a telecoil
fitted by the hearing care professionel.
Installing neck loop
1. Detach neck loop R10 from receiver jack R9 by pulling the loop wire.
2. Place the T-DEX on the chest and place loop wire around the neck.
3. Reattach neck loop R10 to receiver jack R9.
4. Switch hearing aid to T (telecoil only) or MT (microphone and telecoil simultaneously) position.
Setup
R9
R10
R9
2 3 1
2
3
5
Please note:
• Connecting headphones
to the headphones jack R8
disconnects the signal to
the neck loop.
Installing neck loop
T-DEX