Westermo ODW-622 - Manual (Page 18)

18 6650-2234
Configuration
All needed configurations and parameter settings are done by the DIP-switches, located
under the top lid of the ODW-622.
!
DIP-switch settings
Before DIP-switch settings:
Prevent damage to internal electronics from electrostatic discharges (ESD) by
discharging your body to a grounding point (e.g. use of wrist strap)
Note: Disconnect power before DIP-switch settings.
S2 S1
S1 DIP-switch
ON
1 2 3 4 5 6 7 8
CTS always active
ON
1 2 3 4 5 6 7 8
RTS signal will be transferred to
remote modem. When the remote
modem receives RTS. CTS will be
set to high.*
ON
1 2 3 4 5 6 7 8
300 bit/s
ON
1 2 3 4 5 6 7 8
1 200 bit/s
ON
1 2 3 4 5 6 7 8
2 400 bit/s
ON
1 2 3 4 5 6 7 8
4 800 bit/s
ON
1 2 3 4 5 6 7 8
9 600 bit/s
ON
1 2 3 4 5 6 7 8
19.2 kbit/s
ON
1 2 3 4 5 6 7 8
38.4 kbit/s
ON
1 2 3 4 5 6 7 8
57.6 kbit/s
ON
1 2 3 4 5 6 7 8
115.2 kbit/s
ON
1 2 3 4 5 6 7 8
125 kbit/s
ON
1 2 3 4 5 6 7 8
187.5 kbit/s
ON
1 2 3 4 5 6 7 8
230.4 kbit/s
ON
1 2 3 4 5 6 7 8
250 kbit/s
ON
1 2 3 4 5 6 7 8
9 bits data format
ON
1 2 3 4 5 6 7 8
10 bits data format
ON
1 2 3 4 5 6 7 8
11 bits data format
ON
1 2 3 4 5 6 7 8
12 bits data format
* Only point-to-point application (end unit).