Westermo FD-40 - Manual (Page 15)

15 6630-2242
6.4.3 Off-line configuration by FD-Tool
This part will only describe the usage of FD-Tool to perform an off-line configuration.
For FD-Tool installation and general FD-Tool handling, see “FD-Tool installation manual.”
Initiate a new off-line configuration
• Start the FD-Tool.
• Select the device type by selecting File > Configuration > New (default / device)
and Select Group in Device Selection window. The selected group has to be the same
as the FD-40 device, for which the configuration will be used.
• FD-Tool will show the device type of this FD-40 for which all configuration parameters
have to be set.
Modify configuration
Configurations are defined per device type, see “Functional description”, chapter 7.
FD-40 B Buffered
Load configuration to FD-40
• See “On-line configuration by FD-Tool”, chapter 6.4.2.
6.4.4 Save, load and modify configuration files by FD-Tool
Save configuration to disk
• The present configuration can be saved to disk as a file, to be used for future configu-
rations of the same device type, by selecting File > Configuration > Save to disk
• An arbitrary file name can be used, saved as a *.cnf file.
Load and modify a disk stored configuration
• Load configuration from disk by selecting Configuration > Load from disk
and open the wanted configuration file (*.cnf).
• FD-Tool shows the device type of this FD-40 with the present configuration.