Westermo DDW-100 - Manual (Page 9)

9 6621-2202
Diagnostic information:
The DDW-100 can display diagnostic information using a terminal. program
1) Connect a Westermo standard cable 1211-2026 (two metre 9-pole D-sub)
to the RS-232 interface located under lid.
2) Open a terminal program with settings:
Data rate: 115.2 kbit/s
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
3) Type command DIAG or RUNDIAG
Information from DIAG command
• Software release
• DIP switch settings
• If the unit is configured as CO or CPE
• If the unit is configured for Annex A or Annex B
• DSL link state
• DSL data rate
• DSL noise margin
• Ethernet data rate
• Ethernet duplex
Information from RUNDIAG command
DSL Link state
DSL Datarate
DSL Noise Margin
Space aborts running diagnostics.
1211-2026
RS-232