Westermo DDW-100 - Manual (Page 14)

14 6621-2202
S1* DIP-switch
DIP-switch settings
Before DIP-switch settings:
Prevent damage to internal electronics from electrostatic discharges (ESD)
by discharging your body to a grounding point (e.g. use of wrist strap).
NOTE DIP-switch alterations are only effective after a power on.
A setting configured by any other method during normal operation, overrides
the DIP-switch setting. However, at power up, the DIP-switch settings have prec-
edence over the setting configured by any other method.
!
S1 S2
ON
1 2 3 4 5 6 7 8
Ethernet Auto-negotiation enabled.
Auto MDI/MDI-X.
10 Mbit/s auto-polarity enabled.
Auto-negotiation enabled, CPE, 192 kbit/s
ON
1 2 3 4 5 6 7 8
Speed 100 Mbit/s *
ON
1 2 3 4 5 6 7 8
Speed 10 Mbit/s *
ON
1 2 3 4 5 6 7 8
Full-Duplex, FDPX *
ON
1 2 3 4 5 6 7 8
Half-Duplex, HDPX *
ON
1 2 3 4 5 6 7 8
Central, CO
ON
1 2 3 4 5 6 7 8
Remote, CPE
ON
1 2 3 4 5 6 7 8
192 kbit/s
ON
1 2 3 4 5 6 7 8
384 kbit/s
ON
1 2 3 4 5 6 7 8
512 kbit/s
ON
1 2 3 4 5 6 7 8
768 kbit/s
ON
1 2 3 4 5 6 7 8
1.024 Mbit/s
ON
1 2 3 4 5 6 7 8
1.280 Mbit/s
ON
1 2 3 4 5 6 7 8
2.048 Mbit/s
ON
1 2 3 4 5 6 7 8
2.304 Mbit/s
* Configured as MDI • S1: 8 are not used
Factory settings
ON
1 2 3 4 5 6 7 8
S1