Westermo MR-2x0 - Manual (Page 23)

23 6622-2221 • 29000447
Step-by-step guide to configure a GPRS/3G/HSPA connection using
the web interface
ANT.
(AUX.) 9-48V
DC
ASY 0
ANT.
(MAIN)
LAN
Power Connection
Antenna connectors
PC/Ethernet
connection (RJ-45)
ANT. WWAN
(Main)
ANT. WWAN
(Aux.)
11-58V DC
1,3 A
MAIN AUX. ASY 0 LAN3 LAN2 LAN1 LAN0
Power Connection
Antenna connectors
PC/Ethernet
connection (RJ-45)
Step 1 – Power-up the unit and wait for it to become ready
Connect the antenna(s) to the unit and insert the SIM card into slot 1. Connect an RJ-45
cable from a/the LAN port to your PC, and then connect the unit to an appropriate PSU
and power it up.
The unit will then start up and after about 10 seconds the unit will be accessible via the
web-interface.
Step 2 – Configure your PC
Make the following changes in your PC.
IP address 192.168.2.100*
Netmask (Ethernet ports) 255.255.255.0
Gateway 192.168.2.200
Preferred DNS server 192.168.2.200
* Can be any address in the 192.168.2.0-255-range except 192.168.2.200.
Note! If you are unsure or unable to change the above – consult your network
administrator.