Welltech WR5100 V.1.0 - Manual (Page 7)

Welltech Computer Co., Ltd.
Network
WR5100 has 2 network interfaces:
- Management interface: it is used for management purpose
- SIP service interface: provide SIP service over this network
Step 1:
After successfully logon to the system, we need to change the
network configuration. Click Control > Network to setup the SIP
Service Interface parameters as figure 2.2-1.
Figure 2.2-1
Step 2: Enter the deserved IP address, Submask and default gateway or
selected to “Use DHCP”. Apply the change by clicking apply button as
figure 2.2-2.
Figure 2.2-2
Step 3:
When screen shows “Change network configuration may cause
server disconnected, are you sure?” click on OK button to changes
IP address as figure 2.2-3.
Figure 2.2-3
Step 4: When screen shows “After configuration changed, please re-login
system with new IP address and execute Soft-Reset!” click OK
button as figure 2.2-4.
Figure 2.2-4
WellSIP Telephony Server – V2.0 - 7 -